Check Point 61000 Manual de Serviço descarregar pdf (Página 38)

Showing Chassis and Component Status (asg monitor)

Monitoring and Configuration Commands Page 38

Parameter

Description

interval

Monitors SGM state and running processes. Enter a

decimal value in seconds, for example: asg monitor

-v interval

Monitors chassis parameters. For example: asg

monitor –v 3.

-all interval

Monitors all SGMs and chassis parameters

Example 1

asg monitor

Output

Comments

This shows:

 The date and time when information was last collected

 Chassis 1 is ACTIVE with three Security Gateway Modules up

 Chassis 2 is in STANDBY state with three Security Gateway Modules up

 Security GW State is the state of the Security Gateway Module. The state can

 Up

 Down

 Detached.

A state can have one of these Processes:

 Enforcing Security - The SGM is UP and working properly.

 Inactive - The SGM is DOWN, and is experiencing some problem. It is

not handling any traffic.

 Initial policy - The policy is not installed on the SGM.

To manually change the state of an SGM, use the asg_blade_admin

command. Remember that this command administratively changes the state

to up or down. An SGM physically down can not be changed to UP using this

command.

(local) - represents the SGM on which you ran the command.

Example 2

asg monitor -v

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 46 47

Sem comentários

Check Point 61000 Manual de Serviço Página 38