Check Point 4000 Manual de Serviço descarregar pdf (Página 26)

Configuring Check Point 4000 Appliances

26 | Check Point 4000 Appliances Getting Started Guide

Web/SSH and GUI Clients Configuration

Define the clients that are allowed to connect to the appliance using a web browser or SSH

client. These clients can manage the appliance using a web or SSH connection.

You can define a Host according to Hostname or IP address. Enter a comma-separated list of

IP addresses from which you manage the appliance. Enter Any to manage the appliance from

anywhere.

Note - Do not use the Any value for security reasons.

After you complete the First Time Configuration Wizard, more options are available using the

WebUI menu.

SIC Setup

Configure the SIC (Secure Internal Communication) settings for a Centrally Managed

appliance. Enter a SIC Activation Key. The same key is used by the gateway object in

SmartDashboard.

Summary

The Summary page opens.

Click Finish to complete the First Time Configuration Wizard. You can log in to the appliance

after some minutes.

Note - You should back up the system configuration. Open

the WebUI interface and go to Appliance > Backup and

Restore.

Creating the Network Object

Configure the Check Point 4000 Appliances as a gateway object in the Security Management

Server database.

To create the network object in SmartDashboard:

1. Launch SmartDashboard.

2. Configure a new gateway object for the appliance.

3. Enter the IP address for the appliance.

4. For a centrally managed installation, establish Secure Internal Communication (SIC) using

the activation key entered in the First Time Configuration Wizard.

5. Configure the topology.

6. Install the security policy.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 26