Check Point 4000 Manual de Serviço descarregar pdf (Página 42)

Restoring Factory Defaults

42 | Check Point 4000 Appliances Getting Started Guide

3. Configure the terminal emulation program:

 In the HyperTerminal Connect To window, select a port from the Connect using list.

 In PuTTY select the Serial connection type.

4. Define the serial port settings: 9600 BPS, 8 bits, no parity, 1 stop bit.

5. From the Flow control list, select None.

6. Connect to the appliance.

7. Turn on the appliance.

8. The appliance initializes and status messages are shown in the terminal emulation

program.

9. When this message is shown, you have approximately four seconds to hit any key to

activate the Boot menu.

10. The Boot menu opens. Scroll to the relevant Reset to factory defaults image and press

Enter.

Restoring Using the LCD Panel

To restore the appliance to its default factory configuration using the LCD Panel

keys:

1. Reboot or power on the appliance.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 42