Check Point 4000 Manual de Serviço descarregar pdf (Página 38)

Check Point 4000 Appliances Hardware

38 | Check Point 4000 Appliances Getting Started Guide

Installing the Power Supply

This section describes how to install a power supply or placeholder unit into a Check Point

4800 appliance.

To install a replacement power supply:

1. Insert the power supply or placeholder unit into the power supply slot.

2. Push the power supply or placeholder unit until the release lever clicks.

3. Insert the power cord into the power supply socket. Make sure that the green LED is

illuminated.

Expansion Line Card

This section presents the procedures for removing and installing an expansion line card unit.

There are two types of expansion cards that can be installed: Ethernet or Fiber Optic ports. The

built-in Ethernet ports (LAN1 - LAN8) are not customer replaceable.

Important - Make certain that you are electromagnetically grounded when

performing the following procedures. Static electricity can damage the appliance.

Installing Expansion Line Cards

To install an expansion line card:

1. Turn off the appliance.

2. Remove the power cords from the power supply units.

3. Loosen the retaining screws on the metal cover on the front of the appliance.

4. Holding the screws, remove the metal cover.

5. Insert the expansion line card into the expansion slot.

6. Push until the card clicks into position.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 38