Check Point 4000 Manual de Serviço descarregar pdf (Página 34)

Check Point 4000 Appliances Hardware

34 | Check Point 4000 Appliances Getting Started Guide

Configuring Management IP Addresses

You can use the LCD panel to configure these management interface IP addresses for the

appliance:

 Management IP address

 Subnet netmask

 Default gateway

To configure the management IP address using the LCD panel:

1. Press Enter .

The panel shows Select > Network.

2. Press Enter .

The panel shows Network > DHCP.

3. Press Down .

The panel shows Network > Set Mgmt IP.

4. Press Enter .

The panel shows the management interface IP address.

5. Configure the management interface IP address.

a) Press Up or Down, or , to change the digit.

b) Press Right or Enter, or , to move to the next digit.

c) When the panel shows the correct IP address, move the cursor to the last digit and

press Enter .

The panel shows Network > Set Mgmt IP.

6. Do steps 3 - 5 again for the subnet netmask and the default gateway IP address.

7. Press Esc until the panel shows the appliance logo.

Expansion Line Cards

Check Point 4000 Appliances contain one optional expansion slot that accommodates cold-

swappable network line cards. There are different types of expansion line cards which contain

two, four, or eight ports. These types of expansion line cards are currently available:

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 34