Check Point 4000 Manual de Serviço descarregar pdf (Página 35)

Check Point 4000 Appliances Hardware

Check Point 4000 Appliances Getting Started Guide | 35

Model

Description

CPAP-2-10F

2 Port 10GBase-F SFP+ (without transceivers)

CPAP-4-1C

4 Port 10/100/1000Base-T RJ-45

CPAP-4-1F

4 Port 1000Base-F SFP (without transceivers)

CPAP-8-1C

8 Port 10/100/1000Base-T RJ-45

Hard Disk Drives

Check Point 4000 Appliances contain one hard disk drive that is not hot-swappable. You must

power off the appliance before removing or installing a hard disk drive.

Rear Panel Components

This section describes components located on the rear panel of the appliance.

Main Power Switch

The main power switch controls power to the entire unit.

Redundant Power Supply Units (Check Point 4800)

The Check Point 4800 has an optional redundant power supply unit. Located at the left rear of

the appliance, two hot-swappable power supply units give built-in power redundancy. Each

power supply connects to an electrical outlet.

For appliances that are provisioned with one power supply unit, use the placeholder unit in the

other power supply slot. This diagram shows the 4800 model with the placeholder unit:

Note - If both power supply slots are not populated, a continuous alarm sounds.

If a power supply fails or is not connected to the outlet, an alarm sounds continuously.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 35