Check Point 4000 Manual de Serviço descarregar pdf (Página 4)

Safety, Environmental, and Electronic Emissions Notices

4 | Check Point 4000 Appliances Getting Started Guide

Safety, Environmental, and

Electronic Emissions Notices

Read the following warnings before setting up or using the appliance.

Warning - Do not block air vents. A minimum 1/2-inch clearance is

required.

Warning - This appliance does not contain any user-serviceable parts. Do

not remove any covers or attempt to gain access to the inside of the

product. Opening the device or modifying it in any way has the risk of

personal injury and will void your warranty. The following instructions are for

trained service personnel only.

To prevent damage to any system board, it is important to handle it with care. The following

measures are generally sufficient to protect your equipment from static electricity discharge:

 When handling the board, to use a grounded wrist strap designed for static discharge

elimination.

 Touch a grounded metal object before removing the board from the antistatic bag.

 Handle the board by its edges only. Do not touch its components, peripheral chips, memory

modules or gold contacts.

 When handling processor chips or memory modules, avoid touching their pins or gold edge

fingers.

 Restore the communications appliance system board and peripherals back into the

antistatic bag when they are not in use or not installed in the chassis. Some circuitry on the

system board can continue operating even though the power is switched off.

 Under no circumstances should the lithium battery cell used to power the real-time clock be

allowed to short. The battery cell may heat up under these conditions and present a burn

hazard.

Warning - DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY

REPLACED. REPLACE ONLY WITH SAME OR EQUIVALENT TYPE

RECOMMENDED BY THE MANUFACTURER. DISCARD USED

BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.

 Disconnect the system board power supply from its power source before you connect or

disconnect cables or install or remove any system board components. Failure to do this can

result in personnel injury or equipment damage.

1 2 3 4 5 6 7 8 9 ... 48 49

Sem comentários

Check Point 4000 Manual de Serviço Página 4